Archive for the ‘Design’ Category
Bamboo Bike Build – Part 3 – Final Touches
The final step in this build was to install the rear wheel bridge and brake mount. I wasn’t really sure about the best way to go about this, but after a few minutes in Home Depot I found a few metal nuts that I could epoxy into the bridge to give the brakes a proper support. After aligning the bridge and the nuts at the right angle I epoxied them in place and wrapped them in hemp. Once it had cured 48hours later I sanded everything down and drilled a hole through the hemp to expose the metal mount for the brake. Perfect fit.
See also:
Digital Design for The Liberal Part of Canada – Falling Maple Leaf
I was recently approached to design an animated logo for The Liberal Party of Canada. I have ABSOLUTELY no political association with them, but they liked my work:
Junkyard Beer Fridge Project
I recently found an old rusty vintage refrigerator at the dump heading for the scrap pile. I scoped it out, and figured it still looked like it might work, plus I needed a new fridge for my home-brew. So I took it home, plugged it in and it clicked on immediately… so I got to work. After a few hours of sanding, painting, drilling and re-insulating… here is the result: